Ist die Wahl einer Zentrifugalpumpe oder einer volumetrischen Pumpe in einem pharmazeutischen Labor?
Performance:
In order to be able to select the type of pump that is suitable in the pharmaceutical laboratory, it is necessary to have a deep understanding of its performance and understand the difference in its specific working principle. To this end, we must understand that the centrifugal pump is dependent on the pressure (or The variable flow phenomenon of the indenter, while the positive displacement pump has a more or less constant flow phenomenon independent of the pressure.
Viscosity:
The centrifugal pump and the positive displacement pump are also different in viscosity, and the flow rate drops when the viscosity rises, and the positive displacement pump actually causes an increase in the flow rate. This is because the higher viscosity liquid fills the voids in the volumetric pump, resulting in higher volumetric efficiency.
Efficiency:
In pharmaceutical laboratories, it is necessary to consider the effect of pressure on the equipment. After all, different pumps have different characteristics. Different efficiencies will increase the pressure of the pump. For volumetric pumps, as the pressure increases, Efficiency will actually increase, and centrifugal pumps have a better efficiency point. On both sides of this point, the overall pump efficiency will drop significantly.
Entrance conditions:
The pharmaceutical laboratory has different conditions for the inlets of these two types of pumps. The centrifugal pump needs to reserve a certain amount of liquid in the pump to form a pressure difference. The liquid-free dry pump cannot be started by itself, due to the volume. The pump agitates the liquid by the expansion and contraction of the liquid volume, and the negative pressure is formed at the inlet, so the volumetric pump can initiate the perfusion. In some cases, this is the decision whether to choose the volumetric pump or the centrifugal pump. Elements.
The selection of different pumps in the pharmaceutical laboratory is to be selected according to their own needs. It takes a lot of time to get the right choice to get a higher benefit.
Verwandte Empfehlungen
-
Kühlungs-Simulationssystem für die Prüfung der extremen Leistung von Batteriepacks
1683Mit der Entwicklung der Technologie werden reine Elektrofahrzeuge immer häufiger, aber reine Elektrofahrzeuge sind schwierig, eine bessere Lösung in Bezug auf Reichweite, Ladegeschwindigkeit und Umweltverschmutzung nach Batterieabfall zu bekommen. Dies macht...
Details anzeigen -
Hoch- und Niedertemperatur-Heiß- und Kaltwasserkühlmaschine für den Test von Batteriemotoren
1631LNEYA Hoch- und Niedertemperatur-Kalt- und Warmwasserkühler werden für das Wärmemanagement der Batterie von Elektrofahrzeugen mit neuer Energie verwendet. Das folgende ist das relevante Prinzip im Wärmemanagement angewendet.die hohe und niedrige Temperatur kalt und...
Details anzeigen -
Working Principle and Process of Chiller Temperature Control and Pressure Controller
2533Air cooled chiller temperature controller is a two - position regulator, also known as chiller temperature control relay.According to the change of adjusted temperature,the chiller temperature control makes the contact on or off, thus controlling ...
Details anzeigen -
Introduction of distillation principle and temperature cycle control device
1492Distillation is a common method for purifying liquid substances and separating mixtures. The boiling point of the compound can also be measured by distillation, so it also has a certain significance for the identification of pure liquid organic co...
Details anzeigen
LNEYA Industriekühler Hersteller Lieferant










